33kv 3X120qmm Copper Conductor/ XLPE/Swa/PVC Power Cable

Conductor material: Bare copper

Conductor construction: Stranded, class 2

Insulation: XLPE

Sheathing material: PVC

Colour of outer sheath: Red or other

Flame retardant: VDE 0482-332-1-2/IEC 60332-1

Maximum temperature at 90 ° C
Conductor:

Max. Operating temperature, +70 ° C
Fixed:

Temperature, moved/during -5 – +70 ° C
Installation:

Bending radius, fixed 15 x DA
Installation:

Partial discharge: 2 pC

N2XSY 6/10 kV N2XSY 12/20 kV N2XSY 18/30 kV
Nominal voltage Uo: 6 kV 12 kV 18 kV
Nominal voltage U: 10 kV 20 kV 30 kV
Maximum permitted 12 kV 24 kV 36 kV
Operating voltage in 3-phase
Systems:
Test voltage: 21 kV 42 kV 63 kV

Application: For installation in ground, in water, outdoors, indoors and in cable ducts for power stations, industry, and
Distribution networks. The good installation properties of this cable make installation easy, even on difficult routes. Acc.
To VDE 0276-603 cables must be protected against direct sun irradiation.

Nominal Cross-sectional Areas:
1.5 mm2, 2.5 mm2, 4 mm2, 6 mm2, 10 mm2, 16 mm2, 25 mm2, 35 mm2, 50 mm2, 70 mm2, 95 mm2, 120 mm2, 150 mm2, 185 mm2, 240 mm2, 300 mm2 400 mm2 500 mm2 630 mm2 800 mm2

Production Range:
Single core cable from 1.5 mm2 to 800 mm2, muli-core cable from 1.5 mm2 to 400 mm2

Operating Characteristics:
Rated power-frequency voltage u0/u: 0.6/1 KV 3.6/6KV 12/20KV 18/35KV…
Max permissible continuous operating temperature of conductor 70
Max short-circuit temperature of the conductor shall not exceed (Max 5 seconds duration): Cross-section of conductor 300 mm2

The ambient temperature under installations should not be below 0

The bending radius of single core cable should not be less than 20 times of the cable diameter, the bending radius of multi-core cable should not be less than 15 times of the cable diameter.