10kv T Cable Connector/Tee Body Connector/Separable Connector

unscreened connector system

The HAIVOL unscreened connector system is a right angled adapter designed  to fit over standard MV cable terminations when used with equipment  bushings to Type C according to EN 50180 and EN 50181.

The RUSC boot can be easily disconnected for testing and then  reconnected with standard tooling under dead break conditions.  The body is made from Silicon rubber based material with excellent antitracking properties.

The body and termination are not screened and therefore during  operation the surfaces will be considered live and must not be touched.

1.For Voltage Range 6/10(12)kV up to 8.7/15(17.5)kV 

2.For connection to C type bushings according to EN 50180 and EN 50181 

3.Tested to CENELEC HD 629.1 

4.One size is suitable for all cable types from 70 – 300mm2 

5.Easy to install with comprehensive instructions included in each kit  

6.Unlimited shelf life at normal storage temperatures

Kit Contents: 3 x RUSC Boots , 3 x Silicone Grease , Installation Instructions

silicone rubber adapter to be used on  Insulators of Medium Voltage Compartments of the C interface type  Bushing in the Medium Voltage Switchgears Where there is a heat or cold shrinkable air insulated termination and  you want to connect these to the C interface Bushing of new  Switchgears without necessarily replacing the termination with a  separable T connector, you can use the HAIVOL adapter called RUSC24
RUSC24 is an adapter that allows the connection between the air  termination and the C interface bushing without requiring cutting of the  conventional termination itself. When cutting that termination, often there is no cable available for the  assembly of a new separable T connector and in such cases it is  necessary to make a joint outside the substation with the use of a cable  loop between joint and new T connector. Using the RUSC24 adapter avoids all this!