ADSS Cable Fitting Aluminium Alloy Dead End Grip Amour Rods

Introduction

The suspension clamp is  provided with black weather-resistant plastic coating of at least 1mm thickness to prevent the insulation of the phase conductors from chafing due to rubbing against the clamp.

Material

1.Body and Pressure Pad:weather resistant aluminum alloy.

2.Plastic protection:weather and UV-radiation resistant plastic.

3.Nuts,washers&Bolt:hot-dip galvanized steel.

Detail specification

(Performance testing) 
2.1 Mechanical performance:the grip force of the wire clamp is 1/10 bigger than the break force of the lead. It comply with GB2314-1997 
2.2 Temperature rise performance: under the conditìon of big current, the temperature rise of connector is less than that of connection lead.
2.3 Heat circle performance:confirms to GB/T2317.3-2000,the beat circle trial standard for electric fitting. 
2.4 Waterproof insulatìon performance:confirms to the relevant requirements in Part 2 of GB/TI3140.4-1998, 
2.5 Resistance to corrosion performance: under the conditìon of SO, and salt fog, it can do three tìmes of fourteen days circle testìng. 
2.6 Environmental aging performance:under the circumstance of ultraviolet, radiation, dry and moist, expose if with change of temperature and beat impulse for six weeks. 
2.7 Fire-proof performance: insulation material of the connector withstands glowing filament test. Confirm to the requirements in Chapter4-1 0 of GBrr5169.4