Aluminium Alloy Dead End Strain Clamp

Type Selection Requirements:
The type of tension clamp is chosen in accordance with wires for electrical power transmission line in general.

As the tension clamp is worked on the outer diameter of wires,the type of tension clamp to be used should be selected according to the outer diameter of wires when using ACSR wires.

Compared with bare conductors,the insulated wires take the advantage of high safe reliability,lower line loss and smaller wire corrosion and son on.It should be noted that the tension clamp is worked on the outer diameter of wires instead of the outer diameter of conductors.This leads to the type of tension clamp should be selected according to the outer diameter of wires instead of conductors when using insulated wires.

Installation:
If the grip strength of wire clamp cannot meet the specified requirements when installing larger section ACSR with bolt type tension clamps, the compression type tension clamp must be used by technicians.

Advantage:
– Convenient installation: Don’t need to use special tools, do not need to cut the wire.
– We do not need to cute the wire, reduced the electrical contact point, low loss, energy-saving effect of transmission line is more significant.
– Safety and reliability for greatly increased.
– The body and the wedge core of bolt type tension clamp is made of high strength aluminum alloy materials, can  provide more grip and failure load.
– Have self-locking function, the wire is pulled tight trend. The product can be reused after removal.

>>——————————————————————

>>——————————————————————