China Power Line Hardware Hot-DIP Galvanized Piercing Connector Clamp

Installation:

Firstly,adjust nut to suitable position,insert the branch completely into the branch cap;
Secondary,insert main line,If the main line has two layers of insulation leather, the outer insulation leather of a certain length should be removed at the connecting position;
Thirdly,take the main line and branch line to suitable position and keep them parallel,tight up the nut to fix the clamp by hand;
Finally,tight up the nut with spanner of corresponding size until the top end cracks and falls down.

Firstly,turn on the clamp,then insert main line into main line groove,pay attention that the main line is not skew and the diameter is match with the clamp.;
Secondary,take the branch line into branch line groove;
Thirdly,tight up with spanner,the open spanner is forbidden;
Fourthly,pay attention that the two nuts should be turned down simultaneously;
Finally,the installation finished when the constant torques nut cracks by certain force.