Underground Cable with PVC Insulation and PVC Sheath Nayy Nyy Cable

Application range
Power and control cable for fixed installation in the following applications:
For indoor and outdoor use
Burial without additional, suitable underground protection according to VDE standard HD 603/VDE 0276-603 – Part 3-G (point 4)
Governing PVC cables for direct burial: Normal minimum installation depth 0.6 m, but at least 0.8 m under roads
In concrete with a temperature below the maximum cable operating temperature of +70 ° C according to the VDE standard HD
603/VDE 0276-603 – Part 3-G (point 4) governing PVC cables for direct burial
In water: No longer than 2 weeks at a time, maximum submersion depth 10 metres, only in static water/bodies of water without
Shipping traffic

Product Make-up
Aluminium conductor
Abbreviations "re", "rm", "se", "sm": R = round conductor form; S = sectorial conductor form; E = single-wire conductor (wire =
Conductor)/braided conductor class 1 according to IEC 60228/VDE 0295 for fixed, static applications; M = multi-wire
Conductor/braided conductor class 2 according to IEC 60228/VDE 0295 for fixed, static applications, but with a slightly lower
Minimum bending factor
Core insulation: Based on PVC
Filling compound over the core assembly
PVC-based outer sheath
Norm references / Approvals
HD 603/VDE 0276-603
Product features
Flame-retardant according IEC 60332-1-2
Maximum tensile strain for aluminium conductors during installation is 30 N/mm² According to HD 603/VDE 0276-603: Part 1
Appendix A. 4.12 and Part 3-G point 4
Current rating according to HD 603/VDE 0276-603, Part 3-G, Table 14 (buried at +20 ° C ground temperature according to HD
603/VDE 0276-603, Part 3-G, point 5) for routing underground and Table 15 (in the air at an air temperature of +30 ° C
According to HD 603/VDE 0276-603, Part 3-G, point 5) when used outdoors; But always taking into consideration
Corrections/reductions to the current rating that may be necessary according to VDE 0298-4, and VDE 0298-4 (also refer to the
Catalogue appendix T12) for installation in and on buildings

Technical Data
Core identification code: According to VDE 0293-308 (table T9)
Classification: ETIM 5.0 Class-ID: EC000057
ETIM 5.0 Class-Description: Low voltage power cable
Conductor stranding: Single-wire
Minimum bending radius: Fixed installation: 12 x outer diameter
Nominal voltage: Uo/U: 0.6/1.0 kV
Test voltage: 4000 V
Temperature range: During installation: -5° C to +50° C
Fixed installation: -30° C to +70° C