Fhj (C) Type 10/20kv Lightning Protection Puncture Wire Clip Lightning Protection Fittings

1. Lightning protection arc clamp is a product with a new structure, which is mainly composed of insulation shield, wire clamp seat, puncture pressure block, compression nut arc ball and grounding plate and other details.
2. Lightning protection fittings, the bottom of the lightning protection wire clamp seat is the arc ball with spherical structure. When a lightning strike occurs, there is discharge between the arc ball and the ground plate, so that the continuous power frequency arc moves to the arc ball metal ball and burns. thus play a protective role.
3. Lightning protection fittings, lightning protection arc clip insulation shields are made of organic composite materials, which have good insulation performance, anti-aging performance and flame retardant performance. Assembling it outside the wire clip seat can play a role of insulation protection . The insulating shield is made of organic composite material, which has good insulation performance, anti-aging performance and flame retardant performance. It can be assembled outside the wire clamp to play a role of insulation protection.

1. The wire clamp groove of lightning protection pillar insulator should be installed on the cross arm parallel to the conductor, and the steel foot nut should be secured, which is equivalent to the traditional installation method of insulator, and the arc leading rod should be directed towards the far side of the cross arm (the furthest distance from the cross arm); The arc starting rod should be oriented in one direction, preferably towards the load side;
2. There are two methods of perforation and clamping: (1) Tightening method of the torque nut: insert the insulated wire into the slot as parallel as possible, first tighten the torque nut by hand, and then use a socket wrench to alternately and evenly tighten until the torque The top of the nut comes off. (2) According to the cross section of the wire and the weather temperature, set the torque wrench value to 20-35Nm, and use the torque wrench to tighten the two pressure nuts alternately and symmetrically. The root is enough, and then tighten the backup nut to prevent the pressure nut from loosening;
3. The non-piercing method of wire clipping is: strip off a section of insulated wire of about 65-80mm, wrap it with aluminum clad tape and embed it on the insulator wire clipping hardware. Tighten the compression nut with a wrench to drive the compression block to compress the wire, so as to assemble the insulating sheath to the outside of the compression metal fixture. (For details, please refer to the product installation manual)

1. Ambient temperature of -40 degrees to +50 degrees c
2. Altitude not exceeding 2000m
3. Power frequency is 50~60Hz
4. The maximum wind speed of no more than 35m/s
5. Seismic intensity of 8 degree and below